DECAL WATER TRANSFER IMAGE - Bohemian Plants & Geometry

CLEAR BACKGROUND

Size - Overall decal size size: 9.5cm x 13.5CM

On clear background, FOR USE WITH LIGHT COLOURED CLAY AND SURFACES ONLY. PLEASE NOTE THAT DUE TO SOME MONITORS AND SCREENS THERE MAY BE A VARIATION IN COLOUR BETWEEN THE ORIGINAL ITEM AND THE DIGITAL PICTURE

For use with polymer clay and many other materials for all your creative desires!

Condition and prepare your polymer clay, cut it out using your chosen cutter. Bake clay according to manufacturers recommendations. Sand your clay pieces ensuring the surface you wish to place the decal on is smooth and dust free. Turn decal sheet over so you are looking at the backside, trace around your shape (desired decal design side facing the white backing of decal paper). Cut out your shape using your scissors, leaving a small border. Place the decal in clean room temperature water, submerge for 30-60 seconds or until the backing paper slides off easily. Remove the decal from the water. Place the decal on your clay piece being gentle and careful not to tear. Slowly slide the white backing paper from between the clay piece and the image. Using a wet finger very gentle push out any water from behind the decal or any air bubbles. Allow to dry naturally for 3 hours out of direct sunlight. Cure your decal in the oven at 110 degrees Celsius for 15 minutes, allow to cool slowly. Remove piece and coat with desired sealer or resin, pieces must be sealed or design will rub off.

View our YouTube tutorial for a demonstration.